Table 1. DST options (continued)

 

Paging environment

 

 

 

 

 

DST options

D-IPL (non-paging)

Limited

Full

 

 

 

 

Work with disk units

Yes

Yes

Yes

 

 

 

 

Work with DST environment

Yes

Yes

Yes

 

 

 

 

Work with Licensed Internal Code

No

Yes

Yes

 

 

 

 

Work with remote service support

Yes

Yes

Yes

 

 

 

 

Work with save storage and restore storage

No

Yes¹

No

 

 

 

 

Work with system partitions

No

Yes¹

Yes¹

 

 

 

 

Work with system capacity

No

Yes

Yes

 

 

 

 

Work with system security

No

Yes

Yes

 

 

 

 

Note: ¹ Indicates that this option is operating system-dependent. It is available only under certain operating systems (see Appendix A, “OS/400 Operating System” on page 281).

Installing Licensed Internal Code

This option allows you to install or restore Licensed Internal Code. For more information on how to use this option, see “Utilities to Install and Restore Licensed Internal Code” on page 225.

Attention: Doing this to a system with multiple partitions can cause damage to the partition configuration and loss of data.

This option is available only in the stand-alone environment.

Installing the operating system

Select the Install the operating system option from the Use Dedicated Service (DST) Tools display.

This option installs the operating system from removable media (for example, tape). The present operating system (if any) is replaced. Use this option to install a new release of the presently installed operating system or to install the operating system after a failure. You must run this option from the primary console.

This option is not available under basic DST authority. For more information about authority, see “Work with service tools user IDs” on page 25.

Perform an IPL

Select the Perform an IPL option from the Use Dedicated Service Tools (DST) display.

This option allows you to load and start the operating system from the disk. If you have installed the Licensed Internal Code and there is no operating system installed, load and start the operating system from the same removable media device as the Licensed Internal Code.

Work with Licensed Internal Code

This option applies PTFs, removes PTFs, or makes PTFs permanent to the system Licensed Internal Code from removable media when the operating system is not available. It also allows you to rebuild the Licensed Internal Code, display the

Chapter 1. Dedicated Service Tools (DST) 11

Page 25
Image 25
IBM SY44-5902-05 manual Installing Licensed Internal Code, Installing the operating system, Perform an IPL