IBM SY44-5902-05 manual More information from hexadecimal reports

Table 8. Hexadecimal dump byte assignments for non-keyed data (continued)
Hexadecimal offset	Length in bytes	Description
00EE	4	Component ID
00F2	8	Version/Release/Modification
00FA	50	Resource paths
012C	10	Power controlling system (PCS) name
0136	10	Power controlling system (PCS) serial
		number
0140	10	Resource at log time
014A	4	Frame ID
014E	2	EIA location
0150	12	Part number
015C	1	Protocol
015D	1	Format of data
015E	1	Delayed reporting
015F	1	Signal event
0160	4	Secondary code
0164	2	Flags
0166	2	State at log time
0168	4	Power controlling system (PCS) type
016C	4	Power controlling system (PCS) model
0170	8	Reserved
0178	2	Component record format
0176	2	Statistics offset
017C	4	Component data length
Table 9. Hexadecimal dump byte assignments for variable component specific data
Hexadecimal Offset	Length in Bytes	Description
0180		This field is different for each log entry and
		is intended for engineering use only.
		However, see “More information from
		hexadecimal reports” for examples of how
		the hexadecimal information can be
		interpreted for a D-IPL.

More information from hexadecimal reports

You can get additional information for IOP 90xx reference code product activity log entries at DST by using a D-IPL.

Note: The term I/O processor may indicate an IOP or an IOA.

Below are examples of how to interpret hexadecimal information for a D-IPL. Note: Formatting is available (F4=Additional Information) for IPL from disk (A- or

	B-IPL). Formatting is not available in DST from a D-IPL.
Use the information below and the example displays on the following pages to
interpret the hexadecimal dump information that begins at offset hex 000180. If the
characters at offset 00019F are:
01	Device formatting
02	Array Member formatting
03	Configuration formatting
04	Array addendum formatting

Chapter 3. Product Activity Log 117