IBM SY44-5902-05 manual Save the system configuration data to the file you created

7.Compare the label that is attached to the cable or device with the name that appears in the Label column on the printout.

vIf the label that is attached to the cable or device matches the information in the Label column, do not create a label.

vIf one of the following occurs, you must create and attach a label to the cable:

a.There is information in the Label column, but no label is attached to the cable.

b.The label that is attached to the cable does not match the information in the Label column.

c.A label is attached to the cable, and *NONE appears in the Label column.

Note: If no label is attached to the cable, *NONE indicates that it is not necessary to attach a label to the cable.

8.Find the blank labels that came with the upgrade shipment.

9.Create a label for each cable or device that you identified:

a.On the blank labels that were provided, write the information that appears in the Label column.

10.Use the Card Position, Device Position, Type-Model, and Serial Number columns on the printout to assist in locating the devices.

Note: If an asterisk (*) appears in the Location and Serial Number columns, the label is no longer associated with hardware in the system. You do not need to create a label.

Attach the labels to the cables and devices that you identified.

11.Keep the Display Description Label Locations printout you might want to use it during the Test Procedure portion of the upgrade.

12.Press F3 (Exit) until you reach the Main Menu.

Attention: If you replace the labeled cable or device during the hardware install of the upgrade, ensure that you transfer the label from that cable or device to the replacement cable or device. If you cannot remove the label without damaging it, copy the information onto a new label and attach it to the replacement cable or device.

13.Ask the customer to sign on as QSECOFR. Have the customer save the system configuration to a file by performing the following:

a.Create a file to store the system configuration data.

CRTSAVF QGPL/CFGSAVE

b.Save the system configuration data to the file you created.

SAVCFG DEV(*SAVF) SAVF(QGPL/CFGSAVE)

14.Go to the instructions to perform the upgrade.

After completing the upgrade, go to “Using the configuration description label information after a system upgrade” to verify that labels that are attached to the cables or devices match label information in the system.

Using the configuration description label information after a system upgrade

After performing a system upgrade, you must update the configuration description label information in the system to match the information that appears on the (physical) label that is attached to the cable or device.

304Service Functions V5R2