IBM SY44-5902-05 manual Displaying data from function, Logical partitions

3.Press the Increment (↑) or Decrement (↓) buttons until the value of yy appears next to the function number.

4.Press Enter on the control panel.

5.Press the Increment (↑) or Decrement (↓) buttons until ** appears next to the function number (60**).

6.Press Enter on the control panel.

Setting the zz Position

1.Press the Increment (↑) or Decrement (↓) buttons until 61 appears in the Function display.

2.Press Enter on the control panel; ** appears next to the function number.

3.Press the Increment (↑) or Decrement (↓) buttons until the value of zz appears next to the function number.

4.Press Enter on the control panel. Record the data from the display as the base address.

5.Press the Increment (↑) or Decrement (↓) buttons until ** appears next to the function number (61**).

6.Press Enter on the control panel.

You just entered your address into the system. Now use the “Displaying data from function 62” procedure to obtain the information from function 62.

Displaying data from function 62

To obtain information from function 62, do the following steps:

1.Press the Increment (↑) button until 62 appears in the Function display. Press Enter on the control panel.

2.Press the Increment (↑) button until 6200 appears. Press Enter on the control panel and record the data.

3.Press the Increment (↑) button until 01 appears after the function number (6201). Press Enter on the control panel and record the data.

4.Continue until you have the needed data.

5.When you are done, press the Increment (↑) or Decrement (↓) buttons until 62** appears. Press Enter on the control panel.

6.Starting with “Changing the address” on page 134, repeat this procedure until you have recorded all the needed data as defined by the procedure that sent you here.

Call your next level of support and give them the information you collected to write a LIC APAR.

Logical partitions

Logical partitions are the distribution of resources within a single iSeries to make it operate as if it were two or more independent systems.

Attention: The userid/password used to sign on to SST or DST to perform logical partition operations requires ’System partitions - operations’ or ’System partitions - administration’ service tools user privileges. Check with the customer on the proper userid/password to use when performing logical partition procedures.

136Service Functions V5R2