Change Description Label Locations System: xxx

System type-model/serial . . . . . . . : 940x-xxx / xx-xxxxxxx

Select locations where the label on the actual machine or Label Location worksheet does not match the label listed below, press Enter.

2=Change

----------------Location-----------------

 

Frame

 

EIA

Device

Card

 

Opt

ID

 

Location Position Position

Port Label

 

T1

 

 

2

CTL01

 

T1

 

 

3

CTL03

 

T1

 

 

4

*INCORRECT

 

T1

 

 

5

*NONE

 

T1

 

 

4

*NONE

 

T1

 

 

5

DKT01

 

T2

 

 

2

*NONE

 

T2

 

 

3

*NONE

 

T2

 

 

4A

QESLINE, QTILINE, ...

 

More...

 

 

 

F3=Exit

F11=Display types/serial numbers

F12=Cancel F17=Print

Press the F17 key to print a worksheet. If a printer is not available, continue the procedure by noting the information from the displays onto a piece of paper.

Note: Do not use the printout from the Display Description Label Locations display.

10.Use the Change Description Label Locations display or worksheet to verify that all of the system cables and devices are labelled correctly.

11.Compare the label that is attached to the cable or device with the name that appears in the Label column.

v Label information matches if the following occurs:

a.The name on the label that is attached to the cable or device is the same as the information in the Label column on the display.

Note: If you replace the previously labeled cable or device during the system upgrade, be sure to transfer the existing label information to the replacement cable or device.

vLabel information does not match if the following occurs:

a.There is information in the Label column, but no label is attached to the cable. (The following steps of this procedure instruct you to create a label.)

b.The label that is attached to the cable does not match the information in the Label column. (The following steps of this procedure instruct you to change the system label.)

c.*NONE appears in the Label column, and a label is attached to the cable. (The following steps of this procedure instruct you to change the system label.)

d.*INCORRECT appears in the Label column.

This indicates that the label that is attached to the cable does not match the information in the Label column. (The following steps of this procedure instruct you to change the system label.)

12.Does all of the label information match?

306Service Functions V5R2

Page 320
Image 320
IBM SY44-5902-05 manual Location