IBM SY44-5902-05 manual Change resource details, From packaging displays

Device Concurrent Maintenance

Type the choices, then press Enter.

Specify either Physical Location or Resource Name.

>>> Physical Location . . .		Frame ID: 1...		Position: L01.. <<<
OR
Resource Name	. . . . .	Device Resource Name:
Specify action as	1=Remove device		2=Install device
Action to be performed . . . .			. . . . . : 1

Enter a time value between 00 and 19.

Time delay needed in minutes . . . . . . : 00

Serial number of frame (not needed if xxxxxxxxxx shown).

Frame serial number . . . . . . . . . : xxxxxxxxxx

F3=Exit F5=Refresh F12=Cancel

For information on how to perform concurrent maintenance for internal tape or internal optical units, see “Removable Media (Concurrent)” in the Problem Analysis book for your server.

For information on how to perform concurrent maintenance for internal disk units with storage protection, see “Disk Unit (Concurrent)” in the Problem Analysis book for your server.

On some iSeries models informational SRCs occur during concurrent maintenance. These SRCs indicate when it is safe to perform an action or show the status of the action. See “SPCN informational concurrent maintenance SRCs” on page 201 to see the informational SPCN SRCs. For more information about specific SRCs, go to “(1xxx) System Power Control Network (SPCN) Reference Codes” in the Problem Analysis information for your server.

See “Concurrent maintenance” on page 63 for general information about IOA or IOP concurrent maintenance. For removal and installation procedures, see the applicable card removal and installation procedure in the Problem Analysis information for your server.

Collecting information and performing functions from the Hardware Service Manager displays

You can select Packaging hardware resources and Logical hardware resources options from the Hardware Service Manager display (see “Packaging hardware resources” on page 47 and “Logical hardware resources” on page 49). This section describes how to collect information and perform specific functions by using the options and function keys from the various packaging and logical hardware resources displays.

Change resource details

From packaging displays:

Chapter 2. Hardware Service Manager 61