Muratec F-160 operating instructions Review Commands, an introduction, Set # Of Redials # 02-05

When you hear fax tones from the remote unit, press START.

Getting started

To redial a fax call manually with the monitor speaker or an optional handset:

1 Make sure the document is in the feeder and that the resolution and contrast are set.

2 Press MONITOR/CALL or lift the optional handset to get a dial tone.

3 Press REDIAL/PAUSE.

4

Note: If a person answers the phone, use the optional handset to tell that person you’re sending a fax. When you hear fax tones, press START.

To redial a voice call manually using the optional handset:

1 Lift the optional handset to get a dial tone.

2 Press REDIAL/PAUSE. When the other person answers, use the optional handset to speak to that person.

Changing redial settings

It’s up to you how many times the fax redials a number and how long it waits between redials (that length of time between calls is the redial interval). To program the redial settings:

1 Press /PROGRAM, J, 0, 7, ENTER.

Set # Of Redials

#(02-05): 02

2 Use the numeric keypad to enter the number of redials you want. Choose from 2 to 5 redials. In this example, we’ve entered 03.

Set # Of Redials

#(02-05): 03

Important: Enter a leading zero when entering a quantity less than 10.

3 Press ENTER to save the setting.

4 The LCD now shows:

Set Redial Interval

Inter. (3-5): 3

5 Use the numeric keypad to enter the length you want between redial attempts. Choose from 3 to 5 minutes. In this example, we’ve chosen 4.

Set Redial Interval

Inter. (3-5): 4

6 Press ENTER to save the setting.

Review Commands, an introduction

Your fax machine can store many “jobs” in its memory. And it keeps track of each one by assigning it a command number, like “C01.”

Delayed commands, redial attempts and current fax transmissions are all stored in your fax machine’s memory and given a command number.

The Review Commands function gives you the power to check on each job (or command) in your machine’s memory. It also lets you cancel a command if you decide not to send the document.

To cancel a command:

1	Press REVIEW COMMANDS.
	The LCD shows the first command, indicated by its command number and the
	phone number it will dial. If a command is in progress, that will be the first
	command the LCD shows:
		C01:5552009
		Program/Cancel
2
	Press or /PROGRAM until the command you want to cancel appears.
3	Press CANCEL. The LCD shows:
		C01:5552009
		Check Program/Cancel
4
	If you want to cancel this command, press CANCEL again.
5	The LCD now shows the next command.
	If you want to cancel it, too, go back to step 4.

If you don’t want to cancel this command but do want to review other commands, press /PROGRAM until the command you want appears. Then go back to step 4.

If you want to stop reviewing the stored commands, press STOP to return the machine to standby mode.

For more information on the Review Commands function, see page 2.18.

1.16