7 At the end of the operation, your fax machine beeps and displays:
** Complete **
Important: Whenever you transmit a document, what actually appears on the top line of the display depends on information stored in the remote fax. The line may even be blank.
Note: If the call fails, see “Redialling,” next column.
Sending a fax using monitor/call or a handset
You also can fax a document using either the monitor speaker or the optional handset to dial the call.
Note:
1
2 Adjust resolution and contrast if necessary. Press RESOLUTION to change the resolution. Press CONTRAST to change the contrast.
3 Obtain a dial tone, either by:
•Pressing MONITOR/CALL
… or …
•Lifting the optional handset. In either case, the LCD shows:
**Tel Mode **
_
4 Enter the fax number by using the numeric keypad.
Also, enter access codes with the number, just as for a regular phone call.
Note: For information on entering
** Tel Mode ** 919725552009_
5 When you hear fax tones from the remote unit, press START.
Note: If a person answers the phone, use the optional handset to tell that person that you’re trying to send a fax. When you hear fax tones, press START.
Getting started
6 If you’re using an optional handset, hang up after pressing START.
7 At the end of the operation, your fax machine beeps and displays:
** Complete **
Note: If the call fails and you used MONITOR/CALL to dial, press MONITOR/CALL to hang up. Or if you’ve pressed START to begin the fax transmission, press STOP to end it.
Also see “Redialling manually,” below, if the call fails.
Redialling
If your fax call fails, your machine automatically redials it. In this Auto Redial mode, your fax automatically redials the number every few minutes (see “Changing redial settings,” next page) until one of the following happens:
•It reaches the remote fax machine.
•It has attempted the number of redials programmed and has still not connected (see “Changing redial settings,” next page).
While in the Auto Redial mode, the machine can continue to receive faxes and can make as many as 99 fax transmissions.
Note: If you used either the speaker or a handset to dial the call, you must redial manually (see below).
Note: If the last redial attempt fails, your machine may print (and/or display) error messages. For more information, see pages 3.5– 3.9.
Redialling manually
You can always redial calls manually. And you must redial manually if you used either the monitor speaker or an optional handset to dial the failed call.
To redial a fax call manually without using the monitor speaker or an optional handset:
1 Make sure the document is in the feeder and that the resolution and contrast are set.
2 Press REDIAL/PAUSE, START.
1.15
