Paradyne 9128-II, CSU, DSU, 9126-II Dlci Record Options 3, Excess Burst Size Bits, Dlci Priority

4. Configuration Options

Table 4-14. DLCI Record Options (3 of 4)

Bc

Possible Settings: 0 – 1536000

Default Setting: 0

Allows you to display or change the DLCI’s committed burst size.

Display Conditions – This option only appears when Committed Burst Size is set to

Other.

0 – 1536000 – Specifies the DLCI’s committed burst size.

Excess Burst Size (Bits)

Specifies the maximum amount of data in bits that the network may accept beyond the

CIR without discarding frames.

Be

Possible Settings: 0 – 1536000

Default Setting: 1536000

Allows you to display or change the DLCI’s excess burst size.

0 – 1536000 – Specifies the DLCI’s excess burst size.

DLCI Priority

Possible Settings: Low, Medium, High

Default Setting: High

Specifies the relative priority for data received on the DLCI from an attached device (also known as quality of service). All data on Port 1 is cut-through, as long as there is no higher-priority data queued from another user port. The DLCI priority set for an interface applies to data coming into that interface. For example, the priority set for DLCIs on Port 1 applies to data coming into Port 1 from the attached equipment (such as a router).

NOTE: For units with multiple user data ports, since pipelining occurs on Port-1, it is recommended that higher priority data be connected to Port-1 .

Display Conditions – This option is not available for the network interface or, if the model has ISDN backup capability, an ISDN DBM interface.

Low – Data configured for the DLCI has low priority.

Medium – Data configured for the DLCI has medium priority.

High – Data configured for the DLCI has high priority.

Outbound Management Priority

Possible Settings: Low, Medium, High

Default Setting: Medium

Specifies the relative priority for management traffic sent on management PVCs on this

DLCI to the network.

Display Conditions – This option is not available on a user data port or a virtual router port.

Low – Management data configured for the DLCI has low priority.

Medium – Management data configured for the DLCI has medium priority.

High – Management data configured for the DLCI has high priority.

4-66 September 2002 9128-A2-GB20-80