Paradyne 9128-II Class of Service Definitions, Class of Svc Name, Measure Latency & Availability

4. Configuration Options

8.Select Save, then select PgDn or PgUp. The Class of Service Definitions page reappears. In the Code Points Assigned column next to your selected name there is now a Y for Yes.

9.If latency and availability should be measured for the selected name, change the N in the Measure Latency & Availability column to Y.

10. Select Save.

To configure these options, Service Type on the Easy Install screen must be set to Frame Relay.

Table 4-2. Class of Service Definitions

Class of Svc Name

Possible Settings: ASCII Text Entry

Default Setting:

For IDs 2–7: blank

For ID 1: Default

Specifies a name to identify a Class of Service definition.

ASCII Text Entry – Enter a unique name for the definition (maximum length 8 characters).

Measure Latency & Availability

Possible Settings: N, Y

Default Setting:

For IDs 2–7: N

For ID 1: Y

Determines whether latency and availability are measured for this Class of Service ID.

Display Conditions – This option is set to N and is read-only until the class of service is defined and code points are assigned to it.

N – Latency and availability are not measured for this Class of Service ID.

Y – Latency and availability are measured for this Class of Service ID.

Code Points Assigned

Possible Settings: Y, N

Default Setting:

For IDs 2–7: N

For ID 1: Y

This read-only field shows whether a Code Point has been assigned to this Class of

Service ID on the Code Point Definitions screen.

N – No Code Point is assigned to this ID.

Y – At least one Code Point is assigned to this ID.

4-26 September 2002 9128-A2-GB20-80