Paradyne 9126-II, CSU, DSU, 9128-II manual Changing Access Levels, Enable password password, End

6. Security and Logins

Changing Access Levels

he Operator and Administrator have the same Login ID with different passwords for their access level. To determine the level of access for a session, refer to Access Levels (Command Modes) on page 6-14.

After accessing the router’s CLI:

You can access the Administrator access level by entering:

Tenable

The router’s defaults to no password required. To require a password to access the Administrator access level, enter:

enable password password

Once saved, the router responds with a prompt to enter a password for Administrator access. This command is in effect until no enable password [ password ] is entered and saved.

You can end the current Administrator access level by entering:

exit

This command results in ending the current Administrator access level session. Exit may need to be entered several times to reach Operator level and/or end the session.

You can end the Administrator access level by entering:

end

This command results in ending the Administrator access level session and returning immediately to Operator level.

For further details, refer to Chapter 5, Configuring the FrameSaver SLV Router, and Appendix C, Router CLI Commands, Codes, and Designations.

9128-A2-GB20-80 September 2002 6-15