4. Configuration Options
9128-A2-GB20-80 September 2002 4-79
Primary Link
Possible Settings: Net1-FR1, Po rt-
n
, Rtr-S0,
ISDN Link Name
, Clear
Default Setting: Initially blank; no default.
Specifies the frame relay interface to use for this management PVC. The interface
selected must have at least one DLCI (or DLCI with EDLCI) defined, which is not part of a
PVC connection or already assigned as a management PVC.
Display Conditions
– The Port-1 setting does not appear if the PVC is IP Enabled or
Payload Managed is enabled.
Net1-FR1 – Specifies the network interface as the source link for the connection.
Port-
n
– Specifies the frame relay link on the user data port as the destinati on link for the
connection.
Rtr-S0 – For the FrameSaver SLV 9126-II Router, specifies that the vertual router port be
used in the connection.
ISDN Link Name
– For units with ISDN backup capability, specifies the ISDN link on the
DBM to be used in the connection. This can be any nonnull link name configured on an
ISDN frame relay link on an installed DBM.
Clear – Clears the link and the DLCI field, and suppresses the EDLCI fie ld if th e DLCI was
multiplexed.
Primary DLCI
Possible Settings: 16 – 1007
Default Setting: Initially blank; no default.
Specifies the DLCI number used for the management PVC after the frame relay interface
is selected.
The DLCI must be defined for the link (i.e., has a DLCI record), and it must not be part of
a PVC connection or already assigned as a management PVC. For mul ti plexed DLCIs, at
least one EDLCI must be unconfigured for the DLCI.
NOTES:
–DLCI cannot be entered if the Link field is blank.
–Clearing the Link also clears the DLCI.
–When an ISDN DBM is installed and the DLCI assigned to the PVC is in a Backup
Group (see Table4-14, DLCI Record Options), the letter designation assigned to
the group of DLCIs appears next to the primary destination DLCI number on the
Management PVCs Options screen.
16 – 1007 – Specifies the DLCI number (inclusive).
Table 4-18. Management PVC Options (3 of 6)