Paradyne CSU, DSU Modifying Isdn Link Profiles, Main Menu → Configuration → Isdn → Link Profiles

4. Configuration Options

Modifying ISDN Link Profiles

Once an ISDN Link Profile is configured using the Automatic Backup Configuration feature, phone numbers and Calling IDs need to be entered. FrameSaver units with ISDN backup capability can originate or answer calls, as needed, so both phone numbers and Calling IDs are needed.

Procedure

1. Select Link Profiles, then Modify.

Main Menu → Configuration → ISDN → Link Profiles

2.Add a name and phone number to the ISDN Link Profile(s) created by Automatic Backup Configuration.

—Name for the destination entered (e.g., Tampa). The default setting is HQ_Site for the first ISDN Link Profile.

—Phone numbers entered:

For Originating a Backup Call	For Answering a Backup Call
Outbound and Alternate Outbound	Inbound Calling ID1 and ID2
phone numbers	hese are the phone numbers of units
Valid characters can include:	from which calls will be accepted.
Numbers (0–9)	ValidT	characters can include:
Special characters * and #	Numbers (0–9)
TSpaces
Parentheses ( )

NOTES:

Remember to include local dial-out numbers (i.e., 9, then the number).

For every originating (outbound) phone number entered, an answering (inbound) phone number must be entered at the far end, and vice versa.

—Maximum Link Rate (Kbps) set to the appropriate speed, if necessary.

—Caller Identification Method set to Proprietary if call validation is not required. The setting must be the same at both ends of the circuit.

—An Alternate Outbound Phone Number should a call using the primary Outbound Phone Number be unsuccessful, if desired.

3.Save the configuration.

See Table 4-11, ISDN Link Profile Options, for configuration information.

4-16 September 2002 9128-A2-GB20-80