4. Configuration Options

Configuring the ISDN DBM Interface

For models with ISDN backup capability, select Physical from the ISDN menu to configure the physical characteristics for DBM Interface.

Main Menu Configuration ISDN Physical

When configuring a BRI DBM, refer to Table 4-9, ISDN BRI DBM Physical

Interface Options.

When configuring a PRI DBM, refer to Table 4-10, ISDN PRI DBM Physical

Interface Options.

Table 4-9. ISDN BRI DBM Physical Interface Options

Interface Status

Possible Settings: Enable, Disable

Default Setting: Disable

Determines whether the ISDN interface is available for use.

Enable – The ISDN interface is enabled.

Disable – The ISDN interface cannot be configured, nor can it transmit or receive data. No PVC connections or frame relay DLCIs will be deleted. Disabling the ISDN interface results in the following:

TAll currently connected ISDN calls are terminated.

Alarms or traps associated with this interface are not generated or displayed.

Service Profile ID (SPID) 1 or 2

Possible Settings: 3 – 20 digits

Default Setting: Clear

Specifies the SPID number assigned by the ISDN service provider for Bearer channel 1 (B1) and Bearer channel 2 (B2). SPID numbers are used by the switch to identify which ISDN services the DBM can access. All blanks is a valid setting.

3 – 20 digits – You can enter a SPID number, or you can leave blanks. If a nondigit/ numeric is entered, an Invalid Character (x) message appears at the bottom of the screen. If fewer than three digits/numerics are entered, an Invalid – SPID must be at least 3 digits message appears at the bottom of the screen.

Clear – Clears the SPID field so it can be reentered.

Local Phone Number 1 or 2

Possible Settings: 10 digits

Default Setting: Clear

Provides the telephone number associated with Bearer channel 1 (B1) and 2 (B2). All blanks is a valid setting.

10 digits – Enter the telephone an Invalid Character (x)

number, up to 10 digits. If a nondigit/numeric is entered, message appears at the bottom of the screen.

Clear – Clears the phone number field so it can be reentered.

9128-A2-GB20-80

September 2002

4-45

Page 89
Image 89
Paradyne 9126-II Configuring the Isdn DBM Interface, Isdn BRI DBM Physical Interface Options, Service Profile ID Spid 1 or