List of available editing commands
M-193
MV-8800 Owner’s Manual
Editing a song / pattern
10
This command lets you modify the duration of notes (the length between note-on and note-off). By changing
the duration you can make your recorded performance more staccato or tenuto.
❍
Parameters to specify
•
Magnify
Use this parameter to decrease or increase differences in duration between notes. With a setting of 100%, no
change will occur. Use a setting of 101% or above to make the durations greater, and a setting of 99% or below
to make the durations shorter. For example, a setting of 50% would halve the durations, and a setting of 200%
would double the durations.
•
Bias
Use this parameter to apply a uniform change to all durations. The value you specify will be applied to all of
the current durations, lengthening or shortening them by the same amount. For example to increase all
durations by 10, you would specify a value of +10.
•
Note Range
This specifies the range of note numbers whose duration will be changed. For example if you want to change
the duration of note numbers between C3 and C4, set the left and right values of the Range parameter to “C3”
and “C4” respectively. You can also specify these by striking the pads.
●
For details on all of the parameters and values for the Change Duration command, refer to “CHANGE
DURATION popup” (Screen Guide; p. 40).
●
The Note Range parameter is available if you have accessed the CHANGE DURATION popup from the
SEQUENCE EDIT screen.
Editing the length of the notes (Change Duration)
MV-8800_e.book 193ページ ２００６年１１月１０日　金曜日　午後１時４８分