Expanding the memory
M-324
MV-8800 Owner’s Manual
1.
Turn off the power of the MV-8800 and the connected devices, and disconnect all cables
from the MV-8800.
2.
Turn the MV-8800 upside down, and lay it on its face supported by objects at each corner
so that the panel buttons and knobs are not damaged.
3.
Remove sixteen screws from the bottom panel
at the locations shown in the illustration, and
detach the bottom cover.
4.
Simultaneously spread apart the two white clips located at
both ends of the DIMM socket.
5.
Pull the (old) memory module out of the socket.
6.
Make sure that the cutouts in the (new) memory module are
positioned correctly, and press it directly downward into
the guide slots.
7.
Continue pressing until the white clips pop upward into
position, locking the memory module into place.
8.
Replace the bottom cover as it was originally.
9.
Turn on the power (p. 28).
Please wait until the MV-8800 has finished starting up.
10.
Checking the installed memory as described in Testing the installed memory (p. 321).
Exchanging the memory (removing and installing)
●
Be careful not to cut your hand on any sharp edges of the installation slot, cover, or circuit board.
●
When you lay the MV-8800 on its face, make stacks of magazines or newspapers to support each of the four
corners so that the weight of the unit does not damage the buttons and knobs. Make sure that no pressure is
being applied to any button or knob.
●
If no memory is installed, the display will indicate “No wave memory (DIMM).” Please install memory as
described in Exchanging the memory (removing and installing) (p. 324).
●
If an unsupported type of memory (DIMM) is installed, a message of “Wrong DIMM type! Turn off the power,
and replace with correct one” will appear when you power-on, and the MV-8800 will not operate.