Panel descriptions
M-20
MV-8800 Owner’s Manual
MULTILEVEL button
This button assigns a different level of velocity (playing
strength) to each of the sixteen velocity pads. Striking pad
1 will produce a velocity level of 7, and striking pad 16 will
produce a velocity level of 127 (p. 37).
●
If MULTILEVEL=on or FIXED VELOCITY=on, the force with
which you strike the pad is ignored.
●
Multilevel will be enabled for the velocity pad that you
pressed immediately before pressing [MULTILEVEL].
FIXED VELOCITY button
This button makes a velocity pad ignore the force
(velocity) with which you actually strike; the pad will
always produce a specified velocity value (indicator lit
orange). Use the PAD screen (Screen Guide; p. 174) to
specify the velocity value.
EVENT ERASE button
While recording sequence data, you can erase a specific
note message by holding down [EVENT ERASE] and
pressing the pad that corresponds to the unwanted note
message.
PAD BANKS button
Accesses the PAD BANKS popup (Screen Guide; p. 5).
By switching the sixteen velocity pads to another bank
you can use a larger variety of musical sources. Six patch
banks and 32 audio phrase banks are provided.
QUICK EDIT button
This button lets you edit the sounds that are assigned to
the velocity pads. Strike the pad whose sound you want to
edit, and then press [QUICK EDIT] to access the
PARTIAL EDIT screen (Screen Guide; p. 125) or AUDIO
PHRASE EDIT screen (Screen Guide; p. 155), where you
can immediately edit the sound of that pad.
CLIPBOARD button
This button lets you temporarily store data for the sound
assigned to a velocity pad. Hold down the pad that you
want to store and press [CLIPBOARD], and the pad data
will be copied to the clipboard (the indicator will light red).
When the red indicator is lit, hold down [CLIPBOARD] and
strike a different velocity pad; the data will be copied from
the clipboard to the velocity pad you struck.
●
The contents of the clipboard are preserved until you
perform one of the following actions.
• Turn off the power
• Load a project
• Overwrite the clipboard by copying data to it
• Press [DELETE]+[CLIPBOARD]
DELETE button
To delete the material (partial or audio phrase) assigned
to a velocity pad, hold down [DELETE] and strike that pad.
ROLL button
By holding down [ROLL] and striking a velocity pad you
can produce a roll (rapidly repeated strikes).
●
The spacing between notes of the roll can be set by the PAD
screen (Screen Guide; p. 174) Pad Roll Interval parameter,
or in a popup accessed by pressing [SHIFT] + [ROLL].
●
While you’re playing a roll, aftertouch data is converted to
velocity.
HOLD button
By holding down [HOLD] and striking a velocity pad you
can make the pad stay in the pressed state (the indicator
will light red). Press [HOLD] once again to cancel the hold
function (the indicator will go dark).
VELOCITY PADS
Use these pads to input sequence data and play samples.
Since the pads are velocity-sensitive (i.e., each pad
detects the force with which you strike it), you can use
them to add dynamic variation to your performance. The
pads are also sensitive to polyphonic aftertouch; they can
respond to the force with which you press them after the
initial strike.
MV-8800_e.book 20ページ ２００６年１１月１０日　金曜日　午後１時４８分