Roland MV-8800 Checking the system status, Resetting the MV-8800s parameters to the factory settings

Checking the system status
M-322
MV-8800 Owner’s Manual
While the test is being performed the display will indicate “Now Processing...”
When checking is completed, the result will be displayed.
3.
After noting the result of the test, press [F5](Close).
Here’s how to initialize all system parameters of the MV-8800 to their factory settings.
1.
Access the SYSTEM INFORMATION screen as described in “Viewing the system
information” (p. 321).
2.
Press [F3](Initialize).
The display will ask “Initialize system parameters. Are you sure?”
Display Result
Memory Diagnosis: OK The memory is functioning normally.
Memory Diagnosis: NG A problem was found in the installed memory. Please replace the memory as described
in “Exchanging the memory (removing and installing)” (p. 324).
● If this test produces a result of NG, there is a problem with the installed DIMM. Since data cannot be read/written
correctly to this DIMM, it may cause problems with the operation of the MV-8800. Please replace the DIMM (p.
324).
Resetting the MV-8800’s parameters to the factory settings
● This operation initializes only system parameters; it does not erase the samples or library data saved on the
hard disk.
F-button Action
[F1](No) Cancels the operation.
[F5](Yes) Initializes the system parameters.
MV-8800_e.book 322ページ ２００６年１１月１０日 金曜日 午後１時４８分