Setting for the MV-8800’s sliders and buttons
M-320
MV-8800 Owner’s Manual
●
Using a foot switch
You can connect a Roland DP-2 (sold separately) or Boss FS-5U (sold separately) to the rear panel FOOT
SWITCH jack and use it to operate the MV-8800.
This selects the polarity of the foot switch. Select “Standard” if you’re using a Roland DP-2. If you’re using a
Boss FS-5U, select “Standard” and set the polarity switch of the FS-5U as shown in the diagram.
●
Changing how the sliders and knobs operate
A wide variety of parameters can be assigned to the sliders and knobs. This means that when you switch
screens, the parameter values displayed in the screen may not match the physical location of the sliders and
knobs. You can specify how the parameter will change when you operate a slider or knob in such cases.
Slider Mode specifies how the parameter will change when you operate a slider. Knob Mode specifies how the
parameter will change when you operate a knob.
Value Explanation
Null
The slider (knob) will not begin controlling the value until you move the slider (knob) to a position that
corresponds with the displayed value.
< Example: the slider controls a value in a range of 0 to 10 >
If the slider is positioned at 5 and the displayed value is 2, the displayed value will not change until you
move the slider to the 2 position.
Jump The instant you move the slider (knob), the displayed value will immediately change to the position of
the slider (knob).
Relative Moving the slider (knob) will produce a relative change in the displayed value.
MV-8800_e.book 320ページ ２００６年１１月１０日　金曜日　午後１時４８分