Using the CD-R/RW drive
M-31
MV-8800 Owner’s Manual
Using the CD-R/RW driveIntroduction
• We recommend CD-R discs made by the following manufacturers:
Taiyo Yuden Corporation, Mitsui Chemical Corporation, Mitsubishi Chemical Corporation,
Ricoh Corporation, Hitachi Maxell Corporation
• We recommend CD-RW discs made by the following manufacturers:
Mitsubishi Chemical Corporation, Ricoh Corporation
1.
Press the eject button.
2.
Open the disc tray.
3.
Align the hold of the disc with the round retainer in the center of the CD-R/RW drive.
4.
Press the disc downward until it locks into the three catches of the retainer.
5.
Push the disc tray all the way in.
If, due to a power failure or other reason, the power is turned off with a disc in the tray, you won’t be able to
eject the disc tray by pressing the eject button. If this happens, insert a straightened paper clip (or similar
object) into the emergency eject hole to eject the tray.
1.
Turn off the power of the MV-8800.
2.
Insert a straightened paper clip (or similar object) into the emergency eject hole. The disc
tray will be ejected.
Recommended discsInserting a disc
●
Make sure that the disc is firmly seated in the CD-R/RW drive tray. If the disc is not correctly in position, it may
catch inside the drive and may be impossible to remove.
●
To check whether the disc is correctly in position, try lightly rotating the outer edge of the disc with your finger.
Make sure that the disc does not come off the retainer or fail to rotate smoothly.
If the disc tray fails to open
●
Never use the emergency eject hole to eject the disc tray when the MV-8800 is operating. Doing so may
damage the disc and/or drive, and may cause the disc to fly out.
●
The software locks the eject button while the MV-8800 system is using the CD-R/RW drive. This means that
pressing the eject button in such cases will not eject the tray. This is a design feature for reasons of safety, and
is not a malfunction.
MV-8800_e.book 31ページ ２００６年１１月１０日　金曜日　午後１時４８分