Roland MV-8800 , Modifying data in a selected region (Change Continuous Data)

List of available editing commands
M-199
MV-8800 Owner’s Manual
Editing a song / pattern
10
You can modify data such as volume and pan changes for automation in a selected region.
❍ Parameters to specify
• Event
Specify the type of data that you want to edit.
• Number
Specify the control change number that you want to edit, if you specified Control Change as the Event.
• Note Range
Specify the range of note number that you want to edit, if you specified Poly Aftertouch as the Event.
• Magnify
Use this to increase or decrease the upper limit or lower limit of the selected values.
With a setting of 100%, no change will occur. Use a setting of 101% or above to make the changes greater,
and a setting of 99% or below to make the changes smaller.
For example, a setting of 50% would halve the values and a setting of 200% would double the values. Negative
“-” settings will invert the upper and lower limit values.
• Bias
Specifies the amount by which the data will be increased or decreased.
● For details on all of the parameters and values of the Change Continuous Data command, refer to “CHANGE
CONTINUOUS DATA popup“ (Screen Guide; p. 68).
Modifying data in a selected region (Change Continuous Data)
MV-8800_e.book 199ページ ２００６年１１月１０日 金曜日 午後１時４８分