Toshiba dk14, DK424 3-128, Program *41-2Overview, Program *41-3Overview, System & Station, Notes

System & Station

Program *41 for DK424 – T1 Assignment Series (Part 1)

Important! See Program 17 for other Tie/DID assignments; see Program *17 and Program *09 for other DID assignments.

Notes

●

●

You must cycle system power or run Program 91-2 to transfer Program *41-2 data from temporary memory to working memory. Turn system power Off (five seconds) and On after running Program *41-2.

Always install RDTU PCBs that have Tie or DID channels in slot numbers that are higher than station and Attendant Console PCB slot numbers whenever possible. Each Tie or DID line installed uses a station port in software (see the Configuration worksheets for Tie/DID configuration in the Strata DK I&M Manual).

Program *41-2 Overview

RDTUs provide 8, 16, or 24 channels as set in Program 03. Each channel can operate independently as CO lines (ground start or loop start), Tie lines (Wink or Immediate Start), or DID lines (Wink or Immediate Start). Assign the number of channels for each RDTU with Program 03.

Important! Program 91-2 must be run or System Power must be momentarily turned Off (five seconds) then On for Program *41-2 to take effect.

Program *41-3 – T1 Span Transmit Level Pad Assignments

Initialized Default: 5 (-6dB)

✱ ￿ ✱￿￿ ￿ ✱￿￿ ✱￿￿ ￿ 6SNU ✱ ￿ ￿ +ROG ￿ 6SNU ￿ +ROG

SELECT = 3

Enter the RDTU being programmed (1~8).

RDTU No. 1 2 3 4 5 6 7 8

PAD Code

￿6SNU ￿ ￿ +ROG ￿ 6SNU ￿ ￿ +ROG

Enter one of the following pad codes for the transmission of path:

1= +6 dB pad

2= +3 dB pad

3= 0 dB pad

4= -3 dB pad

5= -6 dB pad (Initialized: PAD_S = 5)

6= -9 dB pad

7= -12 dB pad

8= -15 dB pad

Program *41-3 Overview

The transmission path of each RDTU can be set for one of several pad settings:

Code	Decibel Level
Enter 1	+6 decibel (dB) padding
Enter 2	+3 dB
Enter 3	0 dB
Enter 4	-3 dB

Code	Decibel Level
Enter 5	-6 dB (initialized setting)
Enter 6	-9 dB
Enter 7	-12 dB
Enter 8	-15 dB

3-128 Strata DK Programming 5/00