Toshiba dk14, DK424, DK40I Program 42-1~8- PBX/Centrex Access Codes, Program 42-1~8Overview, 4-10

Toll Restriction

Program 42-1~8 – PBX/Centrex Access Codes

Program 42-1~8 – PBX/Centrex Access Codes

Processor Type: DK14, DK40i, all RCTUs and BCUs

Program Type: Toll Restriction

Initialized Default: Assigns no access codes to PBX groups

✱￿ ✱￿￿ ￿ ✱￿￿ ✱￿￿ ￿ 6SNU ￿ ￿ +ROG ￿ 6SNU

SELECT = 1~8 PBX Access Code Group Enter the PBX Group Number 1~8 that needs an access code assigned.

+ROG ￿ 6SNU ￿ ￿ +ROG ￿ 6SNU ￿ ￿ +ROG

ACCESS CODE = Enter a 2-digit access code for the group, as defined by the table below.

•If access code is single digit, enter the first digit and press LED Button 01 as second digit.

•Press LED Button 01 to delete digit.

•Press LED Button 02 for Wild Card digit (any digit, 0~9). For example, pressing 8 + LED Button 02 allows 80~89.

PBX/Centrex Access Code	PBX/Centrex Outgoing CO Line Access Code(s)
Number	1st Digit	2nd Digit
1
2
3
4
5
6
7
8

Program 42-1~8 Overview

The Centrex access code(s) used to make out-of-centrex calls (usually 9) is entered in this table.

Use this program to allow correct Toll Restriction and Centrex/PBX transfer operation.

Do not use this program when using LCR behind Centrex/PBX; use Program ￿45-2 instead. Also, do not use this program if installing CO lines behind “assume-9” Centrex.

4-10 Strata DK Programming 5/00