Toshiba dk14, DK424, DK40I manual Program *11-0– E911/CAMA Trunk Assignments, Program *11-0Overview

E911

Program *11-0 – E911/CAMA Trunk Assignments

Program *11-0 – E911/CAMA Trunk Assignments

Processor Type: DK40i, all RCTUs and BCUs (Release 4.3)

Program Type: System

Initialized Default: All LEDs Off

✱￿ ✱￿￿ ￿ ✱￿￿

✱￿￿ ￿

6SNU

✱

￿

￿

+ROG

￿

6SNU

￿

+ROG

￿

6SNU

￿

￿

+ROG

￿

6SNU

￿

￿

+ROG

SELECT = 0

Light the LED Buttons that are

marked with an X in the table below.

On=Enabled. Off=Disabled.

LED/Button	X	LED On	LED Off
11		E911 enabled	E911 disabled
10		CAMA trunk 4 not used	CAMA trunk 4 used
09		CAMA trunk 3 not used	CAMA trunk 3 used
08		CAMA trunk 2 not used	CAMA trunk 2 used
07		CAMA trunk 1 not used	CAMA trunk 1 used
06
05
04
03		No internal notification	Internal notification provided
02		CAMA trunk Control Disconnect	Normal disconnect
01		Seven CESID Digits	Ten CESID Digits

Program *11-0 Overview

This program enables E911 calls to be analyzed by the system for appropriate handling. The following assignments in Program *11-0 must be enabled to allow Enhanced 911 (E911) CAMA trunks to operate:

LED 11: CAMA Operation Enabled/Disabled

Led 11 must be turned On to enable the E911 feature to operate.

LED 10~07: CAMA Trunk Circuits Enabled/Disabled

Up to four CAMA (RMCU/RCMS) trunks can be installed on Release 4.0 DK424 and DK424i systems. Turn LEDs 07-10 On to enable the appropriate CAMA trunks (1-4). RMCU/RCMS CAMA trunk circuit are numbered 1~4 from the bottom-up (see the front of the installed RMCU/ RCMS). If only one RCMS is to be installed, place it on the bottom position of the RCMU. The Universal Slot PCB and Universal PCB Wiring chapters of the Strata DK Installation and Maintenance Manual provides details regarding RMCU/RCMS PCB installation and circuit numbering.

LED 03: Internal Notification of E911 Calls Enabled/Disabled

To allow Attendant consoles and station DNs to be called along with the E911 CAMA trunk when a 911 call is made, LED 03 must be turned Off. With this feature enabled, E911 calls will ring the CAMA trunk plus the Incoming Emergency (,1￿(UPJ) button on all Attendant consoles and the [DN] button ([PDN] or [PhDN]) designated in Program *11-8. The designated DN must be programmed to ring telephones in *71, *72, and *73, as required for each telephone on which the designated [DN]appears.

8-4 Strata DK Programming 5/00