Toshiba DK40I, dk14, DK424I manual Isdn, System Programs Overview, Flowchart

4. For PRI, run Program *43 to assign which channel on the PRI link is used for the D-channel. The second assignment specifies the card slot of additional PRI links that are dependent on the master D-channel PRI. The third assignment sets the ID code for the PRI link. For BRI, skip to Step 5.

5. For BRI, run Program *44 to initialize the Service Profile Identifier (SPID) interface. The TE initializes the SPID and sends it to the network. Once the SPID is confirmed from the CO, it does not have to be sent to the switch again.

Strata DK Programming 5/00

Note

These are the only programs relating to RPTU operation that require system power to be cycled Off and On.

Program *63 Set ISDN dialing timers.

To record and enter the data for ISDN system programs

1. Run Program 03-Assign the RPTU (PRI) PCB slot position as type 79. (See Program 03 for DK40i, DK424 or DK424i on Pages 3-4~3-8.) Assign the RBSU without the RBSS piggy- back board as type 77 and the RBSU with the RBSS piggy-back as type 78.

2. For BRI, run Program *60 to assign each circuit for CO line (TE) or Station (NT) operation.

3. Turn system power supply Off (five seconds) and On to activate Program 03 and *60 program data.

*42 Clock Source

*42 Clock Source

2934

network interface.

(SPID) number.

D-channel and

Service Profile ID

Assign the PRI

Initialize BRI

Program *43

Program *44

System power must cycle OFF and ON to effect changes.

*41 T1 Assignments

Program *60 Assign BRI circuits for CO line (TE) or Station (NT) operation.

PRI

BRI

T1

Program 03 Assign BRI or PRI card slots.

ISDN System Programs

ISDN

System Programs Overview

Flowchart 7-1

➤

7-2