Toshiba DK424I, dk14, DK40I Program 10-1– System Assignments, Part 1 of, 3-27, System & Station

System & Station

Program 10-1 – System Assignments, Part 1 of 3

Program 10-1 – System Assignments, Part 1 of 3

Processor Type: DK14, DK40i, all RCTUs and BCUs

Program Type: System

Initialized Default: LEDs 07, 08, 09, 16, 18, 19 and 20 are On

✱￿ ✱￿￿ ￿ ✱￿￿

✱￿￿

￿

6SNU

￿

￿

+ROG

￿

6SNU

￿

+ROG

￿

6SNU

￿

￿

+ROG

￿

6SNU

￿

￿

+ROG

SELECT = 1

Light the LED Buttons that are marked with an X in

the table below.

Button/	X	LED On	LED Off
LED
			Not Allowed
20		Two-CO Line Conference/Allowed	Two-CO line Conference must be allowed for Tandem Line, DISA,
			CF-EXT, and DNIS external routing operation. Also See Program
			15, Code 5.
19		Conference/Allowed	Not Allowed
18		Ring Detect Time-Normal	Ring Detect Time-Short Rings
17		Station to Station Call Volume PAD (-	No Station to Station Call PAD
		8db)
16		BRI Standard Initialization (2 TEIs)	None (TEI = 0)
15~13		Not Used	Not Used
12		ABR Cycles/10 times	15 times	System
11		ABR Redial time/30 sec.	1 min.
10		System Speed Dial Override, Toll	Restricted
		Restriction		&
09		Exclusive Hold/Allowed	Not Allowed	Station
08		Alternate Point Answer	Transfer Privacy
			Not Allowed
07		Ring Transfer of CO Line Allowed	If Ring Transfer is allowed, set Ring Transfer Recall time in Program
			37; if ring transfer is not allowed (LED 07 Off), the station recalls
			immediately if transfer is attempted.
06		CO Line Repeat Ringing	Standard Ring
			Standard ring pattern is 1 sec. on, 3 sec. off.
05		Incoming Call Abandon 8 sec.	6 sec.
			80 msec.
			LED 04 DTMF Signal Time applies to manual and speed dial tones
04		CO Line DTMF Signal Time 160 msec.	sent out of the system via CO lines. This applies when dialing from
			any Toshiba telephone, including the 2000-series Digital Telephone.
			LED 04 does not apply to Call Forward or Voice Mail ID DTMF tones
			sent to voice mail ports. (See Program 10-2, LED 06, for tones sent
			to Voice Mail ports.)
03		Dial Pulse Make Ratio 33%	40%
			CO Line Re-seize guard time 0.45
02		0.45 or 1.5 sec. per Program 42-0	CO line guard time is the time interval the system requires to release
			a CO line and reseize it. If LED 02 is off, all lines are set with 0.45
			second guard time; if LED is on, guard time is 0.45 or 1.5 seconds
			per Program 42-0.
01		Tone First (from SLTs, DKTs and EKTs)	Voice First (from SLTs, DKTs and EKTs)
			This applies to [PDNs] not [PhDNs]; [PhDNs] are always tone first.

Strata DK Programming 5/00 3-27