Toshiba DK424I, dk14, DK40I manual 3-131, Processor Type: DK14, DK40i, all RCTUs and BCUs

System & Station

Program *50 – Caller ID Circuit Assignments to CO Line PCBs

Program *50 – Caller ID Circuit Assignments to CO Line PCBs

Processor Type: DK14, DK40i, all RCTUs and BCUs

Program Type: System

Initialized Default: No RCIU/RCIS circuits assigned

✱ ￿ ✱￿￿ ￿ ✱￿￿ ✱￿￿ ￿ 6SNU ✱ ￿ ￿ +ROG ￿ 6SNU

Processor	CO Line Range
DK14	001~004
DK40i	001~012
RCTUA	001~016
RCTUBA/BB	001~048
RCTUC/D	001~144
RCTUE/F	001~200
B1CU	001~032
B2CAU/BU	000~120
B3CAU/BU	000~120
B5CAU/BU	000~200

￿

+ROG ￿ 6SNU ￿ ￿ +ROG ￿ 6SNU ￿ ￿ +ROG

Run Program 91-2

System power must be cycled or Program 91-2 must be run after completing *50 data entry to transfer data from temporary memory to working memory.

CIUNO = RCIU/RCISU Caller ID circuit number (001~200) or use LED Button 01 to erase data. For DK14, enter the Caller ID interface box line number (001~004).

Any Caller ID circuit can be assigned to any analog ground or loop start CO line circuit. Circuit numbers do not have to match.

CO Line Number

RCIU/RCIS Circuit Number Assigned

CO Line Number

RCIU/RCIS Circuit Number Assigned

CO Line Number

RCIU/RCIS Circuit Number Assigned

System & Station

Note The Tip/Ring leads of RGLU, RCOU, RCOS, and PCOU Caller ID CO lines assigned to RCIU2/RCIS circuits must be bridged at the MDF. The Tip/Ring leads of TCOU and TCIU2 are bridged by the PCB connectors in the DK40i Base KSU.

For more information on RCIU/RCIS assignments and installation, refer to Chapter 7 – Universal Slot PCB Installation and Chapter 8 – Universal Slot PCB Wiring Diagrams in the Strata DK I&M Manual.

On DK14, the Tip/Ring leads of the CO line circuit must be connected to the line Tip/Ring leads of the Caller ID interface box. (See Chapter 1 – DK14 Installation, Figure 1-18 and the Caller ID text under “WSIU1 Serial Interface Board” in the Strata DK I&M Manual.)

Strata DK Programming 5/00 3-131