Toshiba e-Studio200, e-Studio250, e-Studio160 manual Yes

Near the OCT

Is the OCT paper feed sensor working? (using the test mode 04, Sensor Test, DATA No. 9 Bit 4)

NO

YES

1. Check if each connector between the OCT paper feed sensor and the OCT PWA (CN262) is disconnected.

2.Check if each connector between the JSP PWA (CN260) and the relay PWA (CN41) is disconnected.

3.Check if each connector pin is removed or the harness is broken.

4.Check if any conductor pattern on the OCT, relay and main PWA is open- or short-circuited.

5.Replace the OCT paper feed sensor.

6.Replace the OCT PWA.

7.Replace the Relay PWA.

8.Replace the main PWA.

E03

E08

Check to see if there are any foreign obstacles on the recording paper path.

Paper remaining inside the machine at power ON

When recording paper is left inside the machine, remove it. If this error occurs frequently, refer to E01 , E02 and E11 to E19 .

Transporting jam inside the ADU

If recording paper is left in the ADU, remove it. If this error occurs frequently, the following items should be checked.

Do the gears of the drive gear assembly rotate when the ADU motor (Upper) is driven in the reverse direction? (using test mode 10, Output Test, CODE 224)

NO

1.Replace the ADU PWA. 2.Replace the PFC PWA. 3.Replace the relay PWA. 4.Replace the main PWA.

December 2002 TOSHIBA TEC 4 - 5 e-STUDIO160/200/250 TROUBLESHOOTING