
•Avoid exposure to laser radiation during servicing.
–Avoid direct exposure to beam.
–Do not insert tools, parts, etc. that are reflective into the path of the laser beam.
–Remove all watches, rings, bracelets, etc. that are reflective.
4.Main Service Parts for Safety
•The breaker, door switch, fuse, thermostat, thermofuse, thermistor, etc. are particularly important for safety. Be sure to handle/install them properly.
5.Cautionary Labels
•During servicing, be sure to check the rating plate and the cautionary labels such as “Unplug the power cord during service”, “Hot area”, “Laser warning label” etc. to see if there is any dirt on their surface and whether they are properly stuck to the copier.
6.Disposition of Consumable Parts/Packing Materials
•Regarding the recovery and disposal of the copier, supplies, consumable parts and packingm a - terials, it is recommended to follow the relevant local regulations or rules.
7.When parts are disassembled, reassembly is basically the reverse of disas- sembly unless otherwise noted in this manual or other related documents. Be careful not to reassemble small parts such as screws, washers, pins,
8.Basically, the machine should not be operated with any parts removed or dis- assembled.
9.Precautions Against Static Electricity
•The PC board must be stored in an
Caution: Before using the wrist band, pull out the power cord plug of the copier and make sure that there is no uninsulated charged objects in the vicinity.
Caution: Dispose of used batteries and
Attention: Se débarrasser de batteries et
Vorsicht: Entsorgung des gebrauchten Batterien und
December 2002 TOSHIBA TEC |