Toshiba e-Studio250, e-Studio200, e-Studio160 manual Re-install transfer charger unit securely

(3)Blank copy directionFeeding

Step	Cause/Defect area	Check items	Measures
1	Transfer charger unit	Transfer charger unit securely in-	Re-install transfer charger unit securely.
		stalled?
2		Transfer charger wire cut off?	Replace transfer charger unit.
3	Process unit (terminals)	Drum ground terminals/develop-	Clean drum ground terminals, developing bias
		ing bias terminals and corre-	terminals and corresponding terminals of main
		sponding terminals of main body	body.
		stained?
4	Process unit drive system	Is sleeve gear and agitator gear	If any is damaged, replace process unit or
		driven when main motor is manu-	damaged part.
		ally rotated clockwise?
5		Is drum coupling driven when	If any is damaged, replace process unit or
		main motor is manually rotated	damaged part.
		clockwise?
6	Process unit deformation	Process unit deformed?	Replace process unit.
7	Laser scanner unit	Foreign matter or stain on lens?	Remove foreign material or stain with blower.
			(Do not use a cloth.)
8	HVPS (transfer charger and	High-voltage output defective?	Adjust output from HVPS, or replace defec-
	developer bias)		tive HVPS.
9		If problem persists after measures	Replace process unit, laser scanner unit,
		are applied, or there is no prob-	HVPS or main PWA.
		lem found in above check, follow
		procedure described in right col-
		umn.

December 2002 TOSHIBA TEC 4 - 61 e-STUDIO160/200/250 TROUBLESHOOTING