Toshiba e-Studio160, e-Studio250, e-Studio200 manual Completed, Auto Test

End of TEST

Test Items

a) Flash ROM test

b) SRAM test c) DRAM test d) MODEM test e) SCANNER test f) CODEC test g) Printer test

h) Phonebook data test

PROGRAM

Select TEST MODE

SET

Select AUTO TEST

SET

Auto test run

1.2.3 User test mode

When you press the PROGRAM key and enter the TEST mode from the menu, the items that can be tested by the user are displayed.

(1)AUTO TEST

This mode allows the user to independently diagnose the machine by automatically performing a series of tests.

<Key used in operation>

Press the PROGRAM key

Use or keys

Use or keys

It takes about 2 minutes to finish TEST

<Display messages>

PROGRAM

01.DEFAURT SETTINGS 02.LISTS 03.INITIAL SETUP

TEST MODE 01.AUTO TEST 02.INDIVIDUAL TEST 03.TEST RESULT LIST

AUTO TEST

-------------------

AUTO TEST

Completed

Calculates and compares the check sums of the firmware, function data and language information with the previously stored corresponding check sum values.

Same as Function Test.

Same as Function Test.

Same as Function Test.

Same as Function Test.

Same as Function Test.

Checks each part of the printer (fan, HVPS, polygon, heater, LSU) and prints one page of test pattern (not performed when there is no paper). Calculates and compares the check sum of the phonebook with the previ- ously stored check sum value.

i) Network board test (with GF-1110)

e-STUDIO160/200/250 ADJUSTMENT ITEMS 1 - 18 December 2002 TOSHIBA TEC