E15

E19

Tray 3 feeding jam

LCF feeding jam

When recording paper is left on the recording path, remove it. If this error occurs frequently, the following items should be checked.

Is the PFP paper feed sensor (Upper) working? (using the test mode 04, Sensor Test, DATA No.17 Bit 4)

NO

YES

1. Check if each connector between the PFP paper feed sensor (Upper) and the PFP PWA (CN243) is disconnected.

2.Check if each connector between the PFP PWA (CN241) and the PFC PWA (CN206) is disconnected.

3.Check if each connector between the PFC PWA (CN201) and the relay PWA (CN36) is disconnected.

4.Check if each connector pin is removed or the harness is broken.

5.Check if any conductor pattern on the PFP, PFC, relay and main PWA is open- or short-circuited.

6.Replace the PFP paper feed sensor (Upper).

7.Replace the PFP PWA.

8.Replace the PFC PWA.

9.Replace the relay PWA.

10.Replace the main PWA.

Activate the PFP pickup clutch. (using test mode 10, Output Test, CODE 226)

Do the pickup and pickup feed rollers installed on the upper side of the PFP rotate when the PFP main motor is driven? (using test mode 10, Output Test, CODE 109)

NO

YES

1. Check to see if the gears and belt which convey the power of the PFP main motor to the PFP pickup clutch, are damaged.

2.Check to see if each pulley or the timing belt of the PFP pickup assembly is damaged.

Check to see if there are any foreign obstacles on the recording paper path.

December 2002 TOSHIBA TEC

4 - 11

e-STUDIO160/200/250 TROUBLESHOOTING

Page 133
Image 133
Toshiba e-Studio200, e-Studio250, e-Studio160 manual Yes