Toshiba e-Studio200, e-Studio250, e-Studio160 manual Yes

E34

E36

Paper not reach to option cassette feed sensor from tray 3/4

Paper not reach to option cassette feed sensor from LCF

When recording paper is left on the recording path, remove it. If this error occurs frequently, the following items should be checked.

Where was the paper stopped?

Near the registration roller

Is the 2nd feed roller sensor working? (using the test mode 04, Sensor Test, DATA No. 20 Bit 6)

NO

YES

1. Check if each connector between the 2nd feed roller sensor and the PFC PWA (CN205) is disconnected.

2.Check if each connector between the PFC PWA (CN201) and the relay PWA (CN36) is disconnected.

3.Check if each connector pin is removed or the harness is broken.

4.Check if any conductor pattern on the PFC, relay and main PWA is open- or short-circuited.

5.Replace the 2nd feed roller sensor.

6.Replace the PFC PWA.

7.Replace the relay PWA.

8.Replace the main PWA.

Check to see if there are any foreign obstacles on the recording paper path.

Before reaching the 2nd feed roller

Is the 2nd feed roller clutch working? (using the test mode 10, Output Test, CODE 203)

NO

YES

1. Check if each connector between the 2nd feed roller clutch and the PFC PWA (CN205) is disconnected.

2.Check if each connector between the PFC PWA (CN201) and the relay PWA (CN36) is disconnected.

3.Check if each connector pin is removed or the harness is broken.

4.Check if any conductor pattern on the PFC, relay and main PWA is open- or short-circuited.

5.Replace the 2nd feed roller clutch.

6.Replace the PFC PWA.

7.Replace the relay PWA.

8.Replace the main PWA.

Check to see if there are any foreign obstacles on the recording paper path.

e-STUDIO160/200/250 TROUBLESHOOTING 4 - 14 December 2002 TOSHIBA TEC