Toshiba e-Studio200, e-Studio250, e-Studio160 manual CCD Jig CCD unit

(b) Installing CCD unit

When changing CCD unit, install the unit in the fol- lowing manner:

1. With CCD unit temporarily mounted, set the jig. Note: When setting the CCD jig, there must be no space between CCD unit and the spe-

cial CCD jig.

2. Adjust the position of CCD unit for the offset value (unit: mm) provided on CCD unit and then secure it with the screw.

Note: Move the unit to the right of the center when the offset value is plus, and to the left of the center when minus. (one division: 1 mm) and then secure CCD unit.

CCD Jig

	CCD unit
	Fig. 1-8-26	065-03-1
Offset value (+2.00)		CCD unit
	CCD Jig

Ex. The figure below shows an example where the offset value is “+2.00.”

3.After assembling the copier completely, make a copy of document and check the image.

4.If the copy image is enlarged or reduced, read- just.

Fig. 1-8-27

065-04-1

December 2002 TOSHIBA TEC 1 - 83 e-STUDIO160/200/250 ADJUSTMENT ITEMS