E14

Tray 2 feeding jam

When recording paper is left on the recording paper path, remove it. If this error occurs fre- quently, the following items should be checked.

Where was the paper stopped?

Near the registration roller

Is the 2nd feed roller sensor working? (using the test mode 04, Sensor Test, DATA No. 20 Bit 6)

NO

YES

1. Check if each connector between the 2nd feed roller sensor and the PFC PWA (CN205) is disconnected.

2.Check if each connector between the PFC PWA (CN201) and the relay PWA (CN36) is disconnected.

3.Check if each connector pin is removed or the harness is broken.

4.Check if any conductor pattern on the PFC, relay and main PWA is open- or short-circuited.

5.Replace the 2nd feed roller sensor.

6.Replace the PFC PWA.

7.Replace the relay PWA.

8.Replace the main PWA.

Check to see if there are any foreign obstacles on the recording paper path.

Before reaching the 2nd feed roller

Is the 2nd feed roller clutch working? (using the test mode 10, Output Test, CODE 203)

December 2002 TOSHIBA TEC

4 - 9

e-STUDIO160/200/250 TROUBLESHOOTING

Page 131
Image 131
Toshiba e-Studio160, e-Studio250, e-Studio200 manual Yes