EA3
Paper remaining in finisher at power ON
Is there paper remaining on the transport path in the finisher?
YES
NO
Remove the paper.
Is the connector J10 on the finisher controller PWA disconnected?
Is the harness connecting the finisher controller PWA and inlet paper sensor broken?
YES
NO
Connect the connector securely. Replace the harness.
Is the inlet paper sensor working properly? (Check the movement of the actuator.)
NO
YES
1. Connect the connector of the inlet paper sensor securely.
2.Attach the actuator securely if its shaft is out of place.
3.Replace the inlet paper sensor.
Replace the finisher controller PWA.
EA4
Finisher front cover opened during printing
Is there paper remaining on the transport path in the finisher or main unit?
YES
NO
Remove the paper.
Is the finisher connected to the main unit?
NO
YES
Connect the finisher to the main unit.
Is the connector J11 on the finisher controller PWA disconnected?
Is the harness connecting the finisher controller PWA and finisher joint sensor broken?
YES
NO
Connect the connector securely. Replace the harness.
Is the inlet paper sensor working properly?
NO
YES
1. Connect the connector of the finisher joint sensor securely. 2. Replace the finisher joint sensor.
Replace the finisher controller PWA.
December 2002 TOSHIBA TEC | 4 - 27 |
