TMP92CZ26A

92CZ26A-130

3.7.7 Port 9 (P90 to P92, P96, P97)

P90 to P92 are 3-bit general-purpose I/O port. I/O can be set on bit basis using the
control register. Resetting sets P90 to P92 to input port and all bi ts of output latch to”1”.
P96 to P97 are 2-bit general-purpose input port.
Writing “1” in the corresponding bit of P9FC en ables the respectiv e functions.
Resetting resets the P9FC to “0”, and sets all bits to input ports.
(1) Port 90 (TXD0), Port 91 (RXD0), Port 92 (SCLK0, 0CTS )
Port 90 to 92 are general- purpos e I/O port. T hey ar e als o use d either SIO 0. E ach pin
is below.
SIO mode
(SIO0 module)
UART, IrDA mode
(SIO0 module)
P90 TXD0
(Data output)
TXD0
(Data output)
P91 RXD0
(Data input)
RXD0
(Data input)
P92 SCLK0
(Clock input or
output)
0CTS
(Clear to send)
Figure 3.7.14 P90
Internal data bus
Selector
A
B
S
Selector
A
B
S
P90 (TXD0)
TXD0 output
P9 read
Direction
control
(
on bit basis
)
P9CR write
Function
control
(
on bit basis
)
S
Output latch
P9 write
Reset
P9FC write
Open-drain enable
P9FC2<P90F2>