TMP92CZ26A

92CZ26A-363

Table 3.15.2 Operation in the slave m od e

<TRX> <AL> <AAS> <AD0> Conditions Process

1 1 0
The TMP92CZ26A loses arbitration
when transmitting a slave address and
receives a slave address for which the
value of the direction bit sent from
another master is “1”.
1 0
In Salve Receiver Mode, the
TMP92CZ26A receives a slave address
for which the value of the direction bit
sent from the master is “1”.
Set the number of bits a word in
<BC2:0> and write the transmitted data
to SBIDBR
1
0
0 0
In Salve Transmitter Mode, a single
word of is transmitted.
Check the <LRB> setting. If <LRB> is
set to “1”, set <PIN> to “1” since the
receiver win no request the data which
follows. Then, clear <TRX> to “0” to
release the bus. If <LRB> is cleared to
“0”, set <BC2:0> to the number of bits in
a word and write the transmitted data to
SBIDBR since the receiver requests
next data.
1 1/0
The TMP92CZ26A loses arbitration
when transmitting a slave address and
receives a slave address or GENERAL
CALL for which the value of the direction
bit sent from another master is “0”.
1
0 0
The TMP92CZ26A loses arbitration
when transmitting a slave address or
data and terminates word data transfer.
1 1/0
In Slave Receiver Mode, the
TMP92CZ26A receives a slave address
or GENERAL CALL for which the value
of the direction bit sent from the master
is “0”.
Read the SBIDBR for setting the <PIN>
to “1” (reading dummy data) or set the
<PIN> to “1”.
0
0
0 1/0
In Slave Receiver Mode, the
TMP92CZ26A terminates receiving
word data.
Set <BC2:0> to the number of bits in a
word and read the received data from
SBIDBR.