Xerox 701P21091 manual Seffnt MAP, REP Replace

Specifying input parameters

Table 2-49. SEFFNT SEFMAP parameter options and definitions (Continued)

	Option	Definition
	REP	REPLACE
		Indicates that the specified font pairs create a new mapping table to replace
		the current one.
	Default		No default
SEFFNT SEFMAP			• When specified without a label preceding the SEFFNT
parameter: points			command, SEFMAP puts all font mapping definitions within
	to note		the JDL, rather than creating a separate mapping file.
			• When SEFMAP is coded outside of a standard JSL (either
			prior to a JDL command or after an END command), the
			system creates a file named label.LIB on the disk. This file
			contains the font mappings for reference within the JSL by
			other JSLs or through a DJDE.
			NOTE: The .LIB file that is created by a labeled SEFFNT
			command cannot be imported to, or exported from, the DP
			EPS. You must compile the JSL that contains the labeled
			SEFFNT command, which causes the system to recreate the
			.LIB file.
			• When coded at the catalog level of a JSL, SEF mapping
			applies to all JOBS or JDEs that include the catalog. When
			coded at the job level, SEF mapping specifically assigns a
			mapping to be used with this JOB or JDE.
			• In the parameter (font1, font2) (font2,font3), the fact that font1
			is mapped to font2 and font2 is mapped to font3 does not
			imply that font1 is mapped to font3.
			SEFFNT MAP
			References a previously defined font mapping file (filename) or a
			labeled SEFFNT command defined in the current JSL file.

Syntax SEFFNT MAP = {filename label}

2-46 Using LCDS Print Description Language