Xerox 701P21091 manual Output Papersize parameter example, Output Purge

Specifying print format parameters

OUTPUT PAPERSIZE parameter example

•PAPERSIZE=B4 and PAPERSIZE=(10.12,14.33) produce identical results because they indicate long edge feed, as opposed to short edge feed format. (Refer to the SEFFNT command description in the “Specifying input parameters” chapter, for detailed information on short and long edge feed.)

•To print on B5 and 7 by 10 inch paper sizes, the printer requires the 7 by 10 inch enablement kit (a hardware option) to be installed.

•There are performance considerations when you are switching paper sizes across pitch modes.

•The PAPERSIZE parameter is not supported as a DJDE. Therefore, a JDE page oriented DJDE that calls out the desired paper size is needed.

•If the JSL specifies the paper size using the keyword method (such as USLEGAL, A4, or B4), the form coding must use the same terminology. If the JSL specifies 8.5,14 and your form specifies USLEGAL, an error message is displayed, indicating that the form paper size is too small or too large.

USLETTER and B4 are the only sizes for which the keyword and the x, y expression do not create any incompatibilities.

OUTPUT PAPERSIZE=USLETTER, FEED=MAIN, DUPLEX=NO, NUMBER=(1,1,80),

FORMAT=SMPPOE;

OUTPUT PURGE

Specifies whether or not the system should delete graphic disk files at the end of report. This is applicable only to documents with interleaved graphics.

Syntax OUTPUT PURGE = {NO YES}

4-74 Using LCDS Print Description Language