Xerox 701P21091 manual Where ostkspec is, Output Ostk parameter options and definitions

Specifying print format parameters

OUTPUT OFFSET The OFFSET control of FIRST, ALL, or NONE may be modified parameter: point by the ROFFSET command (refer to the ROFFSET command

to note description in the “Using logical processing” chapter).

If OUTPUT OFFSET=FIRST (or ALL) was specified, and the ROFFSET criteria is satisfied on the first page of a report, the normal offset from the preceding report occurs.

OUTPUT OSTK

Specifies that ordered stocks are used for printing the job.

Syntax OUTPUT OSTK = {ostkspec (ostkspec, ostkspec, ...)}

where ostkspec is:

(stockdef, [mod], [pos], [{RES NORES}], [TABS], [size {DOTS IN CM}]] [, {L P}])

Options

	Table 4-67. OUTPUT OSTK parameter options and definitions
Option	Definition
stockdef	stock definition
	The identifier or name of the ordered stock to be used, and for which feeder
	trays have been identified on the user interface Stock List.
	No default.
mod	modulus
	The number of sheets in the ordered stock. For example, 5 cut tabs would have
	a mod value of 5. The range of values is from 1 to 255.
	The default modulus definition is 1.
pos	position.
	The initial position relative to the mod value. The range of values is between 1
	and mod.
	The default position is 1.
RES	RESET or NO RESET.
NORES	Indicates whether the pos value should be reset at the start of the next report.
	The default is RES.
TABS	Indicates a tab stock is being used.
	The default is no tabs (no option entered).
size	Width of the tab. The value can be specified in DOTS, IN, or CM. This
	parameter applies only when tabs are specified.
	The default is 0.5 in.

4-68 Using LCDS Print Description Language