Xerox 701P21091 Options 62. Trans Djde options and definitions, Trans Djde points to note

Using Dynamic Job Descriptor Entries (DJDEs)

For example, if the initial TOF and BOF values are 2 for every job, a page transition occurs every time a data record is processed because the TOF and BOF have the same value. If a TOF DJDE specifying a value of 1 is processed and the page transition has already occurred, the TOF DJDE value is too late and does not take effect until the next page transition.

•The value option is defined the same as in the VFU command, described in the “Specifying print format parameters” chapter.

•If the value specified in the TOF DJDE is greater than or equal to the BOF (Bottom Of Form) value, the TOF value is set to 1.

TRANS DJDE

Specifies whether or not transparencies are used in the print job.

Type Page oriented

Syntax TRANS = {YES NO}

Options

Table 5-62. TRANS DJDE options and definitions

Option	Definition
YES	Specifies that transparencies are used in the print job.
NO	Specifies that transparencies are not used in the print job.

TRANS DJDE: points to note

•The TRANS DJDE is used to force parameters when transparencies are used and to minimize paper jams. If TRANS=YES is specified, the following parameters are forced:

–DUPLEX=NO

–ACCT=TRAY

–BFORM is ignored.

–For the RPAGE command, the NUBACK parameter is forced to NUFRONT.

5-72 Using LCDS Print Description Language