Xerox 701P21091 manual Default Volume Code parameter points to note, Volume Dbcode

Specifying input parameters

Default

VOLUME CODE parameter: points to note

EBCDIC

•When you run a CODE=NONE job with DUPLEX=YES and SHIFT=YES, you must specify MARGIN in inches.

•Input data is translated according to the CODE selected on the VOLUME command. Any character that is translated into an ASCII X’20’ is truncated after the last significant (non- ASCII X’20’) character in the print record.

•On the DP EPS, trailing spaces are deleted for the current code set only. In addition, translated characters that are beyond the highest character code in the current font are converted to blanks and potentially removed.

VOLUME DBCODE

Specifies which double-byte character code translation table the system will use to interpret the input data.

Syntax VOLUME DBCODE = {keyword id }

Options

Table 2-59. VOLUME DBCODE parameter options and definitions

Option	Definition
keyword	Specifies a specific, standard, system defined double-byte code translation
	table. The available options are:
	• IBM: IBM Nihongo character set (Kanji double-byte character sets)
	• IBMCHN: IBM 5550 code translation table
	• JEF: Fujitsu JEF Kanji double-byte character set
	• KEIS: Hitachi KEIS Kanji double-byte character set
	• USER: Refers to the single unlabeled DBCODE command defined within
		the JDL or JDE.
id	Specifies an identifier label that was used in a previously defined DBCODE
	command to refer to a specific, user-defined code translation table. The id label
	is required when multiple DBCODE commands are contained within the JDL.
Default		No default
		VOLUME DBCS
		Specifies the double-byte character printing mode. Allows
		printing of data streams of intermixed single-byte and double-
		byte characters.

Using LCDS Print Description Language 2-57