Xerox 701P21091 manual Options 64. Output NTO1 parameter options and definitions

Specifying print format parameters

OUTPUT MODIFY	• A CME may be coded within a JSL or coded and catalogued
parameter: points	separately for use by several JSLs. Any CME invoked by a
to note	DJDE must be catalogued separately (refer to “CME
	command,” earlier in this chapter, for further information).
	• If the CME is within the JSL, it must precede a reference to its
	identifier by the MODIFY parameter.
	• Different CMEs may be associated with different copies of a
	report by the use of multiple MODIFY parameters on the
	same OUTPUT command. CME copy ranges may not
	overlap.
	• If different CMEs are associated with different copies of a
	report, or if a CME is applied to some but not all copies of a
	report, then the CMEs are termed copy sensitive. Copy
	sensitive CMEs may not be used if COLLATE=NO, or online
	processing is specified. Refer to the MODIFY DJDE
	description in the “Using dynamic job descriptor entries
	(DJDEs)” chapter for a discussion of how CMEs may be
	changed on a page by page basis within a report ply.
	OUTPUT NTO1
	Specifies, on a report basis, whether all copies of a particular
	report are printed last page to first (n to 1).

Syntax OUTPUT NTO1 = {NO YES n}

Options

Table 4-64. OUTPUT NTO1 parameter options and definitions

Option	Definition
YES	Specifies last to first page printing. To print n to 1, output processing must print
	the report starting with the last page. Therefore, output processing cannot
	begin until input processing has finished with the entire report. It is possible that
	input processing does not recognize the end of a report until it detects the start
	of the next report (header banner page). When YES is specified, the system
	assumes a 50 sheet threshold for the maximum report size to be printed N to 1.
NO	Specifies first page to last (1 to n) printing.
n	number.
	The NTO1 threshold, which specifies the maximum number of pages a report
	may have in order for it to be printed n to 1. If the threshold count is exceeded
	before the end of the report, the system prints the entire report 1 to n.
	The default value of n is 50 physical sheets, but n may range from 1 to 32767.
	When a value is greater than 100, the system generates a warning message.

4-64 Using LCDS Print Description Language