Xerox 701P21091 manual Cycleforms, Parameter Example, Formid, Inkref

Specifying print format parameters

Options

Table 4-48. OUTPUT CYCLEFORMS parameter options and definitions

	Option	Definition
	NONE	Specifies that no form will be added to the associated report page of variable
		data.
	formid	Specifies a 1 to 6 character form file name (may be numeric, alpha, or
		alphanumeric), which exists on the system disk.
	INKS	Specifies that the inks that follow will be used for the forms.
	inkref	Identifies the inks that override the corresponding inks that are specified in the
		ink list of the form. If a form does not contain an ink list, the form is printed in
		black.
	Default	NONE
	OUTPUT	• If multiple CYCLEFORMS are specified in the same
CYCLEFORMS		OUTPUT command, a single list consisting of all these
parameter: points		specified forms is created. The forms are listed in the order
	to note	the names are encountered. The number of form identifiers is
		limited only by the number of forms retained on the disk.
		• CYCLEFORMS and FORMS: Both may be used within a
		report; however, only the parameter that was specified most
		recently is in effect at any given time. If a multicopy report
		specifies CYCLEFORMS, a FORMS DJDE that is
		encountered in the report overrides the CYCLEFORMS
		parameter from that point in every copy.
		• For colored forms: If an inkref that is on the ink list is
		omitted from the command, commas must be used to
		maintain the relative positioning of the remaining ink
		references.
		If more than two inkrefs are specified, the system ignores the
		additional inkrefs.
	OUTPUT	OUTPUT CYCLEFORMS=(form1, form2)
CYCLEFORMS
parameter
	example

4-50 Using LCDS Print Description Language