Xerox 701P21091 Options 33. Ilist Djde options and definitions, Ilist Djde example, Image Djde

Using Dynamic Job Descriptor Entries (DJDEs)

Options

	Table 5-33. ILIST DJDE options and definitions
Option	Definition
‘inkname’	Specifies an ink name that will be part of the ILIST that is defined for the page.
	Note that the ink name is specified within single quotes.

ILIST DJDE example

ILIST = (‘BLACK’, ‘XEROX.RED’)

IMAGE DJDE

In Batch mode, this DJDE defines new imaging parameters for subsequent graphics. In all other modes, it defines imaging parameters for the named graphic.

Type Record oriented

Syntax IMAGE = (imgname, vpos [units], hpos [units] [,T] [,H] [, n / [d]] [, (INKS, inkref1 [, inkref2])])

Options

	Table 5-34. IMAGE DJDE options and definitions
Option	Definition
imgname	image name
	The name of an .IMG file or the name on the DJDE sentinel record of a page
	interleaved graphic immediately following the current page, such as
	GRAPHIC=name). Lowercase characters a through z are converted to
	uppercase.
	The name parameter may be omitted in Batch mode; however, the comma
	before vpos must be coded, because it is a positional parameter.
vpos	vertical position.
	Specifies the vertical position of the top edge of the graphic as a downward
	offset relative to 0,0 on the current physical page. (This is the position that
	would be specified by a PDE BEGIN of 0,0 and a PDE PMODE value,
	PORTRAIT or LANDSCAPE, that is currently in effect).
	Specified as a decimal number with up to three digits to the right of the decimal
	point and may be followed by a space and the units indicator.
	NOTE: The default value for the vpos parameter is 0.

5-44 Using LCDS Print Description Language