Xerox 701P21091 manual Illustration of ways to use Output Offset Parameter Example

Specifying print format parameters

Example 3 The commands in the following figure illustrate use of the offsetting features of the OUTPUT command. The parameter ALL offsets all copies of all reports; FIRST offsets just the first copy of each report and NONE inhibits offsetting.

Figure 4-5. Illustration of ways to use OUTPUT OFFSET

parameter

Example 4

OUTPUT CYCLEFORMS=(FORM1, NONE, FORM3);

or

OUTPUT CYCLEFORMS=(FORM1,,FORM3);

If there are ten pages in the report, either of the above commands would cause FORM1 to be applied to pages 1, 4, 7, and 10; no forms to be applied to pages 2, 5, and 8; and FORM3 to be applied to pages 3, 6, and 9.

Example 5 The commands in the following figure illustrate the use of CYCLEFORMS with multiple copies. Note that every copy of a particular page has the same form, whether COLLATE=YES or NO. The pages in the following example are not logical pages but are one side of a physical sheet of paper.

4-90 Using LCDS Print Description Language