Xerox 701P21091 manual Options 60. Output Invert parameter options Definitions

Specifying print format parameters

Default

OUTPUT IMAGE parameter: points to note

OUTPUT IMAGE parameter example

Top left corner of the portrait or landscape oriented page, scaled at 1/1

•To put an image on a page, use a form with the image, or use the IMAGE DJDE.

•If the UN option is used to define positioning, the UNITS parameter must precede this command.

•The IMAGE parameter must follow the GRAPHICS=BATCH parameter, as these two parameters are order dependent.

•If two IMAGE parameters are listed consecutively in a JDL, the system processes only the second one.

•Existing .IMG files are printed in the system default black ink unless ink references are specified in the INK parameter.

•If ink references are used:

–If one inkref in the list is omitted, commas must be used as place holders to maintain the relative positioning of the remaining ink references.

–If more than two ink references are specified, the additional ink references are ignored.

Following is an example of the OUTPUT GRAPHIC parameter.

OUTPUT GRAPHIC=BATCH, IMAGE=(1 IN,2 CM);

OUTPUT INVERT

Specifies that the content of a page will be inverted 180 degrees when it is printed on the physical page, head to head or head to toe. Inversion is also used for page orientation for finishing functions.

Syntax OUTPUT INVERT = {FRONT BACK BOTH NONE}

Options

Table 4-60. OUTPUT INVERT parameter options and

definitions

Option	Definition
FRONT	Specifies page inversion on front sides.
BACK	Specifies page inversion on back sides.

4-60 Using LCDS Print Description Language