Xerox 701P21091 manual Default Line LPI parameter points to note Syntax Options, Line Margin

Specifying print format parameters

Default

LINE LPI parameter: points to note

Syntax

Options

No default

•If the LARGE[ST] is specified for the LINE BASELINE parameter, the LPI parameter is ignored.

•The line spacing value is not based on the maximum LPI font of the line. Instead, it is based on the value that is specified in the command:

LINE LPI = LINESPACING

LINE MARGIN

Specifies the left printing margin within each logical page.

LINE MARGIN = {value (value, valuetype)}

Table 4-34. LINE MARGIN parameter options and definitions

	Option	Definition
	value	Specifies the distance from the left edge of the logical page (as indicated by the
		current BEGIN value in effect) to the left margin. Has the format nnn.mm (a
		positive decimal number of up to three digits, with up to 2 digits to the right of
		the decimal point).
	valuetype	Unit of measure for the margin value. Available unit options include:
		•	IN (inches)
		•	CM (centimeters)
		• POS (character positions).
		NOTE: When you run a CODE=NONE job with DUPLEX=YES and
		SHIFT=YES, you must specify MARGIN in inches.
	Default		(1, POS)
LINE MARGIN			A value must be specified as an integer (nnn) if its valuetype is
parameter: point			character positions (POS).
	to note		LINE OVERPRINT
			Specifies how overprint lines are handled. (Overprint lines are
			print lines whose carriage control specifies printing with no line
			spacing after the last printed line.)
	Syntax		LINE OVERPRINT = (overopt, disp)

Using LCDS Print Description Language 4-31