Aastra Telecom ATP-CNX-040-01 manual Configure the network settings, Requirements, Procedure

Aastra CNX Installation and Setup Procedures

Configure the network settings

7

Configure the network settings

Requirements

The following is required before you configure the Aastra CNX for the first time:

•The Aastra CNX must physically be connected to your console using an RS-232/DB-9 cable.

•The Aastra CNX must physically be connected to your network interface via the Ethernet port(s).

•The Aastra CNX must be turned on.

•You must be running a terminal emulator on your PC. Terminal emulator must be set as follows:

—	Baud Rate	9600
—	Data	8 bit
—	Parity	None
—	Stop	1 bit
—	Flow Control	None

After powering up the Aastra CNX, a network script runs in a terminal emulator window allowing you to initially configure the unit for your network.

Procedure

The following procedure describes how to configure the network settings.

Note: If at any time during the initial configuration process, you want to backout of the configuration, press <ESC> to cancel.

ATP-CNX-040-01 Rel. 1.3, Doc. Rev. 01.07 1-11